5.4. Using the sysctl Command

The /sbin/sysctl command is used to view, set, and automate kernel settings in the /proc/sys/ directory.

To get a quick overview of all settings configurable in the /proc/sys/ directory, type the /sbin/sysctl -a command as root. This will create a large, comprehensive list, a small portion of which looks something like this:

net.ipv4.route.min_delay = 2
kernel.sysrq = 0
kernel.sem = 250     32000     32     128

This is the same information seen if each of the files were viewed individually. The only difference is the file location. The /proc/sys/net/ipv4/route/min_delay file is signified by net.ipv4.route.min_delay, with the directory slashes replaced by dots and the proc.sys portion assumed.

The sysctl command can be use in place of echo to assign values to writable files in the /proc/sys/ directory. For instance instead of using this command:

echo 1 > /proc/sys/kernel/sysrq

You can use the sysctl command:

sysctl -w kernel.sysrq="1"
kernel.sysrq = 1

While quickly setting single values like this in /proc/sys/ is helpful during testing, it does not work as well on a production system. All /proc/sys/ special settings are lost when the machine is rebooted. To preserve the settings that you would like to make permanent to your kernel, add them to the /etc/sysctl.conf file.

Every time the system boots, the init program runs the /etc/rc.d/rc.sysinit script. This script contains a command to execute sysctl using /etc/sysctl.conf to dictate the values passed to the kernel. Any values added to /etc/sysctl.conf will take effect each time the system boots.